vlbk
28.11.2011, 21:03
Доброго дня всем.
Проблема - после прошивки НР3550 на 8 версию софта, померла HXGS3.
Все бы ничего, есть V24, терминал, CLI и т.д.... Не срослось. При загрузке вижу испраный bootloader, а дальше ошибки disk check и все, только прыгающий курсор. Понижение софта станции до V7, V5 ,V4 ессно ничего не дало. Как жить дальше ?:eek:
waiting for HDLC clock |
RS232 initialized for Output: 19200,8,n,1
waiting for HDLC clock ok
testing DELIC boot: Test O.K.
testing Checksum Firmware: Test O.K.
testing Data-Bus DRAM: Test O.K.
testing Address-Bus DRAM: Test O.K.
testing Pattern 0x55555555: Test O.K.
testing Pattern 0xAAAAAAAA: Test O.K.
testing DRAM teststack area: Test O.K.
testing FPGA register access: Test O.K.
testing PHY identifier value: Test O.K.
Board Selftest complete
Waiting for HDLC clock ok
**************************************************
* HXGS/R3 *
**************************************************
Copyright 2002 Siemens AG
Hardware ID : 0x007D
Serial Number : SN472063420102
Parts List Version : -09
Board Revision : 0x04
Bootrom Version : FW-HXG3-V1.0-04.02.02
Processor speed = 200 MHz
PLB speed = 100 MHz
OPB speed = 50 MHz
Ext Bus speed = 33 MHz
PCI Bus speed = 33 MHz (Async)
PCI Async Ext Clock being used.
Internal PCI arbiter enabled
FPGA Version (CID) : 2
FPGA FW-Version : 1.5
DELIC Version : 17312
-48V Present: : YES
Ethernet Address 1 : 00:0F:BB:0D:F4:82
Ethernet Address 2 : 00:0F:BB:0D:F4:83
CPU - Type : IBM PowerNP NPe405H Rev. A Rev. 0140
- Frequency : 200 MHz
Flash Memory : 32 MByte
DRAM Module : 128 MByte (SDRAM PC100 )
DSP Modules :
DSP Module 0 present: YES - type: "C6203"
HGA Modules:
HGA Module 0 present: NO - type: "None"
HGA Module 1 present: NO - type: "None"
System Start Type: 2
FPGA RESTA : c9
FPGA RESCAUSE : e
VxWorks System Boot
Copyright 1984-2001 Wind River Systems, Inc.
CPU: IBM PowerNP NPe405H Rev. A
Version: 5.4.2
BSP version: 1.2/0
Firmware version: FW-HXG3-V1.0-04.02.02
/tffs/ - disk check in progress ...
"/tffs/core_log/conv.run" is cross-linked on first cluster. Entry remains intact.
"/tffs/data/swverupg.txt" is cross-linked on first cluster. Entry will be deleted.
"/tffs/core_log/conv.run/xt" directory has invalid structure. Entry will be deleted.
/tffs/core_log/conv.run/DESCR
"/tffs/core_log/conv.run/DESCR
C.omm" is an illegal name. Entry will be deleted.
"/tffs/core_log/conv.run/ |Pa.ram" is an illegal name. Entry will be deleted.
"/tffs/core_log/conv.run/ultValue. in" file larger then its chain of clusters Entry will be deleted.
/tffs/core_log/conv.run/
Проблема - после прошивки НР3550 на 8 версию софта, померла HXGS3.
Все бы ничего, есть V24, терминал, CLI и т.д.... Не срослось. При загрузке вижу испраный bootloader, а дальше ошибки disk check и все, только прыгающий курсор. Понижение софта станции до V7, V5 ,V4 ессно ничего не дало. Как жить дальше ?:eek:
waiting for HDLC clock |
RS232 initialized for Output: 19200,8,n,1
waiting for HDLC clock ok
testing DELIC boot: Test O.K.
testing Checksum Firmware: Test O.K.
testing Data-Bus DRAM: Test O.K.
testing Address-Bus DRAM: Test O.K.
testing Pattern 0x55555555: Test O.K.
testing Pattern 0xAAAAAAAA: Test O.K.
testing DRAM teststack area: Test O.K.
testing FPGA register access: Test O.K.
testing PHY identifier value: Test O.K.
Board Selftest complete
Waiting for HDLC clock ok
**************************************************
* HXGS/R3 *
**************************************************
Copyright 2002 Siemens AG
Hardware ID : 0x007D
Serial Number : SN472063420102
Parts List Version : -09
Board Revision : 0x04
Bootrom Version : FW-HXG3-V1.0-04.02.02
Processor speed = 200 MHz
PLB speed = 100 MHz
OPB speed = 50 MHz
Ext Bus speed = 33 MHz
PCI Bus speed = 33 MHz (Async)
PCI Async Ext Clock being used.
Internal PCI arbiter enabled
FPGA Version (CID) : 2
FPGA FW-Version : 1.5
DELIC Version : 17312
-48V Present: : YES
Ethernet Address 1 : 00:0F:BB:0D:F4:82
Ethernet Address 2 : 00:0F:BB:0D:F4:83
CPU - Type : IBM PowerNP NPe405H Rev. A Rev. 0140
- Frequency : 200 MHz
Flash Memory : 32 MByte
DRAM Module : 128 MByte (SDRAM PC100 )
DSP Modules :
DSP Module 0 present: YES - type: "C6203"
HGA Modules:
HGA Module 0 present: NO - type: "None"
HGA Module 1 present: NO - type: "None"
System Start Type: 2
FPGA RESTA : c9
FPGA RESCAUSE : e
VxWorks System Boot
Copyright 1984-2001 Wind River Systems, Inc.
CPU: IBM PowerNP NPe405H Rev. A
Version: 5.4.2
BSP version: 1.2/0
Firmware version: FW-HXG3-V1.0-04.02.02
/tffs/ - disk check in progress ...
"/tffs/core_log/conv.run" is cross-linked on first cluster. Entry remains intact.
"/tffs/data/swverupg.txt" is cross-linked on first cluster. Entry will be deleted.
"/tffs/core_log/conv.run/xt" directory has invalid structure. Entry will be deleted.
/tffs/core_log/conv.run/DESCR
"/tffs/core_log/conv.run/DESCR
C.omm" is an illegal name. Entry will be deleted.
"/tffs/core_log/conv.run/ |Pa.ram" is an illegal name. Entry will be deleted.
"/tffs/core_log/conv.run/ultValue. in" file larger then its chain of clusters Entry will be deleted.
/tffs/core_log/conv.run/