Nicolay1
27.07.2009, 10:18
Добрый день, коллеги!
С утра прям какая-то беда.
Постоянные щелчки при разговоре даже внутри станции.
Кажется, даже при положенной трубке щелчки...
Телефоны зависают, разговор пропадает на секунды.
Ни одного IP аппарата нет.
Что бы это могло быть???
ERR020 16 0 0
ERR057 13 0 0 12 0000B000
ERR0057 Excess invalid input messages from digital sets. Every input message iscounted. When the total count reaches a limit, this error message will be printed and the count is reset to zero. The TN printed is only the TN that generated the last invalid message. Other TNs may have generated earlier messages. If no faults are found on the reported unit then investigate othercards.
ERR5417 00002A17 00000C12
ERR5417 Message received from analog line card contains invalid message type. Themessage is ignored. Format: ERR5417 tttt mmmm Where: tttt = the TN themessage was sent to in internat format mmmm = the message contents
ERR080 18 0 0 1 97 (аппарат M3902)
ERR0080 tn key Key input from software-unequipped add-on module.
Action: Check SL-1 telephone data. Ensure that add-on module is defined andthat key number is less than last key
NWS301 -17 -18
NWS301 -9 -11 -12
NWS301 -7 -8
NWS0301 ls c1 c2 cn Two or more PE cards c1, c2, etc. on loop l shelf s failed the signaling test,or the results of the shelf test varied. LD 30 automatically tests each shelf twoways. If a card number is preceded by a minus sign, one or more units on thatcard were disabled. The fault may be: 1. one or more of cards c1, c2, etc. 2.peripheral buffer or controller for shelf 3. loop cable to PE shelf 4. network cardthe loop. If only one card is listed, an intermittent PE card fault is possible.
NWS401 13 : -0 -5
NWS501 14 : -15
NWS0501 l s c u The telephone at L s c u failed the signaling test. If the unit number is precededby a minus sign, the set was disabled. The fault may be: 1. PE card 2. the telephone set
С утра прям какая-то беда.
Постоянные щелчки при разговоре даже внутри станции.
Кажется, даже при положенной трубке щелчки...
Телефоны зависают, разговор пропадает на секунды.
Ни одного IP аппарата нет.
Что бы это могло быть???
ERR020 16 0 0
ERR057 13 0 0 12 0000B000
ERR0057 Excess invalid input messages from digital sets. Every input message iscounted. When the total count reaches a limit, this error message will be printed and the count is reset to zero. The TN printed is only the TN that generated the last invalid message. Other TNs may have generated earlier messages. If no faults are found on the reported unit then investigate othercards.
ERR5417 00002A17 00000C12
ERR5417 Message received from analog line card contains invalid message type. Themessage is ignored. Format: ERR5417 tttt mmmm Where: tttt = the TN themessage was sent to in internat format mmmm = the message contents
ERR080 18 0 0 1 97 (аппарат M3902)
ERR0080 tn key Key input from software-unequipped add-on module.
Action: Check SL-1 telephone data. Ensure that add-on module is defined andthat key number is less than last key
NWS301 -17 -18
NWS301 -9 -11 -12
NWS301 -7 -8
NWS0301 ls c1 c2 cn Two or more PE cards c1, c2, etc. on loop l shelf s failed the signaling test,or the results of the shelf test varied. LD 30 automatically tests each shelf twoways. If a card number is preceded by a minus sign, one or more units on thatcard were disabled. The fault may be: 1. one or more of cards c1, c2, etc. 2.peripheral buffer or controller for shelf 3. loop cable to PE shelf 4. network cardthe loop. If only one card is listed, an intermittent PE card fault is possible.
NWS401 13 : -0 -5
NWS501 14 : -15
NWS0501 l s c u The telephone at L s c u failed the signaling test. If the unit number is precededby a minus sign, the set was disabled. The fault may be: 1. PE card 2. the telephone set