Приет Всем
Помогите с расшифровкой ошибок. Соединение PRI Euro через релейку.
DTA203 11 0 1
DTA203 11 0 0
DTA203 11 0 2
DTA203 11 0 1 ****
OVL000
>err dta203
>
DTA203 11 0 0

DTA203 loop e
A Group 2 error has been detected by the DTI card. Error (e) = 0 to 1F
(HEX). Translate five binary bits to identify the error. For example
if e = 6 the bits are 0 0 1 1 0, therefore the errors are for MFA and
FA.

B6 = B6 TS16 frame 0 (far-end lost MFA signal)
AIS = Alarm Indication Signal
MFA = loss of Multi-Frame Alignment
FA = loss of Frame Alignment
B3 = B3 TSO non-FAS (far-end Out of Service)

Release: P1

Непонятно как эти HEX и bits переводить.
Спасибо

DTA0203 loop x y
A Group 2 error has been detected by the PRI2 card. The error information is decoded as follows, where x :
4 = LOS (loss of signal)
3 = AIS (alarm indication signal)
2 = LFAS (loss of frame)
1 = LMAS (loss of CRC multiframe)
0 = RAI (remote alarm indication)
Where y:
2 = alarm occurred
1 = alarm persisted
0 = alarm cleared

Example: DTA203 7 4 2 - PRI loop 7 loss of signal occurred.

PhoneMan пишет
DTA0203 loop x y
A Group 2 error has been detected by the PRI2 card. The error information is decoded as follows, where x :
4 = LOS (loss of signal)
3 = AIS (alarm indication signal)
2 = LFAS (loss of frame)
1 = LMAS (loss of CRC multiframe)
0 = RAI (remote alarm indication)
Where y:
2 = alarm occurred
1 = alarm persisted
0 = alarm cleared

Example: DTA203 7 4 2 - PRI loop 7 loss of signal occurred.

Большое спасибо