edison
28.01.2004, 12:20
Выход на РRI сделан через ACOD 9, но после набора 9 остается тот же тон, что и при снятии трубки. Как изменить тональность после 9 или убрать тон совсем?
Если в Мeridiane возможность посмотреть какие цифры и под что задействованы в нумерационном плане?

vv11
28.01.2004, 12:26
По поводу тона после 9 было уже в форуме поищи DTAD. Если вы выходите по ACOD убрать боюсь не получиться. Посмотреть нумерационный план можно в LD 20 набрать PRT->DNB->и при том когда запросит DN ничего не набирать и нажать Enter.

Sergio B
28.01.2004, 17:54
чтобы выключить тон после AC1 надо в LD86 ESN поставить DLTN=NO
Чтобы настроить другой тон:

Spe**** dial tone after access codes takes precedence over the spe**** dial tones after dialed number treatment. To define spe**** dial tones after access codes, NO has to be entered in response to prompt DLTN in LD 86 (to inhibit dial tone to access codes). The access code digits and associated tones would
then have to be defined in response to the DTAD prompt in LD 56.

The following is a summary of the tasks in this section:
1 LD 86 – Enable Spe**** Dial Tones after Dialed Numbers.
2 LD 15 – Configure Spe**** Dial Tones after Dialed Numbers.
LD 86 – Enable Spe**** Dial Tones after Dialed Numbers.

REQ CHG
ESN
DLTN = NO NARS/BARS Dial Tone after dialing AC1 or AC2 access codes.

LD 15 – Configure Spe**** Dial Tones after Dialed Numbers.
Prompt Response Description
REQ CHG
TYPE DTAD Spe**** Dial Tone after Dialed Number data block.
DDGT x...x Dialed digits (1-5 digits).
- TONE a...a Tone to be provided after the dialed digits
Where a...a: (DIAL) = Dial Tone
SPDT = Spe**** Dial Tone
SRC!-SRC8 = Source tones 1-8

vv11
28.01.2004, 17:59
To Sergio_B
Человек пишет: выход в город по ACOD, при чем здесь NARS?
А по поводу DTAD согласен.